Page 8 of 13
Re: Refitting the chrome
Posted: Thu May 09, 2019 4:07 pm
by NigelW
The original piece did and is longer than this repo one, I think I'll try to repair the old one and get it rechromed.
Re: Refitting the chrome
Posted: Thu May 09, 2019 4:24 pm
by Glyn Ruck
Mine is from Barratts but that was approx 5 years ago.
Re: Refitting the chrome
Posted: Thu May 09, 2019 4:35 pm
by NigelW
I'll try a Barratt's one next time I put in an order to them.
Re: Refitting the chrome
Posted: Thu May 09, 2019 4:58 pm
by Albion
Orlando St.R wrote: ↑Thu May 09, 2019 1:35 pm
If you are fitting new chrome spears BD25577/BD25578 from SNGB (parts 29 and 30 on the diagram), you will find sooner or later that on the LH one (29), the pins are too close together and do not fit the holes in the body.
bd25577_bd25578_small.jpg
They are not available from Sng at the moment.
Re: Refitting the chrome
Posted: Thu May 09, 2019 5:06 pm
by Albion
NigelW wrote: ↑Thu May 09, 2019 3:21 pm
This piece of chrome infront of the leaper on my car is not long enough compared to the original piece. I bought it from M Robey's a while back and when I challenged them about the length they said it was the only length supplied and no one had complained before. Has anyone had a similar problem with this piece?
Re: Refitting the chrome
Posted: Thu May 09, 2019 5:53 pm
by cass3958
This piece of chrome infront of the leaper on my car is not long enough compared to the original piece. I bought it from M Robey's a while back and when I challenged them about the length they said it was the only length supplied and no one had complained before. Has anyone had a similar problem with this piece?
Mine also reaches the end as can be seen in my Frosty photo but as I recall it is held in place with a "T" piece and nut under the bonnet and the end slides under the Leaper so you can extend it further out unless the one you have is so short the end is touching the leaper and still goes nowhere near the end of the bonnet.
Re: Refitting the chrome
Posted: Thu May 09, 2019 7:10 pm
by NigelW
I've moved it out as far as I can, it's at least 1/2inch too short.. I've bought two s/h bonnets in the past to make louvres in (keeping the original unmolested) but they didn't fit with the bonnet catch missing the the latch by some margin on the slam panel indicating the original bonnet is longer. I don't know if this is another '64 car anomaly.
Re: Refitting the chrome
Posted: Thu May 09, 2019 7:21 pm
by cass3958
O'dear!
Is yours a 64?
LOL.
I was told once not to fit door skins to my doors as they would never fit in the apertures again. Apparently they did not have CNC machines to cut the panels in the 60's and the doors from one car would never fit another. Do you think this is the same with the bonnets or is yours just very long.
Re: Refitting the chrome
Posted: Thu May 09, 2019 7:51 pm
by NigelW
Yes an early 64. I had a devil of a time fitting a rear door I bought NOS. I think they made these cars up as they went along.
Re: Refitting the chrome
Posted: Fri May 10, 2019 1:42 pm
by Albion
Any thoughts about these?