Rear Bumper

[DevilDog]

On the SNG website, the part number 81-60 says that the bracket was superseded with the motor mount. SNG confirmed this. However, they cannot get the rest of the brackets, i.e., 81-61, 81-62, and 81-63?
Here is a photo from the parts manual. Anyone have a source??????

rearbumper.png (117.73 KiB) Viewed 2889 times

rearbumper1.png (48.94 KiB) Viewed 2889 times

[Glyn Ruck]

Joe, Those rear bumper brackets (61, 62, 63 X 2) are a real problem if you don't have used to refurbish or copy. Robeys are the last people I know that had & they are cleaned out.

You are going to have to find used from somebody that is breaking a car. Remember 420 is the same. My spares were so bad that we tossed them in the skip or I would send them to you as patterns ~ sorry!

rear bumper.JPG (101.89 KiB) Viewed 2883 times

[cass3958]

Archive forum http://www.jagstyperegister.com/forum/v ... pers#p1193 relates to an article I wrote on my new stainless steel bumpers I had made by a company called the HArrington Group. They can be found here. https://groupharrington.com/product/jag ... e-bumpers/
When I sent out my old bumpers to them as a former for the new stainless steel bumpers they also received my old brackets which were rusty and damaged as I had to cut them off. I asked them to make up new brackets for me which they did and they sent them with the new bumpers. They said this was a one off and would not be offering them with the new bumpers and this is noted on the advert about that no brackets are supplied. But I am sure that if there was a demand they would supply them especially if you told them they were no longer available elsewhere. They have the drawings I made with dimensions and the brackets they supplied me fit perfectly. Worth contacting them to find out if they can supply the brackets to register members.
Below is a photo of the stainless steel bumpers and all the bracketry that I received with them.

[DevilDog]

Rob,
I contact them and we shall see. Thanks for the info and the tip. Thanks Jose....we can make them if we need too.

Rob...do you still have the specs and drawings of your brackets in case they cannot make them for me?????

[DevilDog]

Rob,

They do not make them and they do not have your specs. Too bad.

Do you by chance have a copy?

[cass3958]

Rob,

They do not make them and they do not have your specs. Too bad.

Do you by chance have a copy?

I will have a look as I think have a copy and get back to you.

[DevilDog]

Rob....were you able to find your drawings???????

[cass3958]

A crude copy which I will have to redrew for you but I have the dimensions. Sorry I have not posted it yet. Will try and get around to it this weekend.

[DevilDog]

Not in a big hurry Rob...just the thought of you having it is fine. Take your time ole friend.

[cass3958]

Joe I have gone one better than a drawing. In my box of many things I came across two bumper brackets. One for the back and one for the side of the bumper mounts. If you PM me your address I will send both of these to you and you can get your man to copy them for your bumper. They are both in good condition with some surface rust. Sorry I do not have two of each to save you the trouble of having to make some.